Drawing standards manual

Standards for Working Drawings _____ _____ 5 of 19 that subassembly. Unlike an assembly drawing, a subassembly drawing does not show a finished product. Views Assembly and subassembly drawings should show the parts, standard components, and subassemblies in their true positions relative to one another. They should contain the. This drawing standards manual establishes the conventions to be adhered to by engineering and drafting personnel in the preparation, revision, and completion of engineering drawings. This manual sets forth the minimum requirements acceptable at GSFC for the preparation of engineering drawings for flight hardware and ground support systems. The GSFC Engineering Drawing Standards Manual is the official source for the requirements and interpretations to be used in the development and presentation of engineering drawings and related documentation for the GSFC. The Mechanical Engineering File Size: KB.

Electronic bid and record drawing submittals will be reviewed by DFD for conformance with the standards. Failure to conform will require a resubmittal by the A/E. A/E's are to use this instruction manual along with the electronic files on DFD's CAD standards web page to prepare drawings. A list of the electronic files is included in. patient centric design commissioning chapter 2: general requirements. responsibility authority having jurisdiction index-1 architectural design manual - august 1, These standards are not stand-alone requirements; they are intended to augment existing commercial and military standards that are commonly used in drawing development within Naval Engineering programs. Except as noted in this Manual, the following standards shall be considered an integral part of this Manual.

CAD Standards Manual –rev AugINTRODUCTION CAD STANDARDS The purpose of this document is to serve as a specification for producing and delivering CAD drawings for Rutgers University–Institutional Planning and Operations (IPO) Construction Projects. The guidelines are intended to. Assembly drawings. Subassembly drawings (if present) Bill of materials (if not included on assembly and subassembly drawing sheets) Detail drawings. This drawing standards manual establishes the conventions to be adhered to by engineering and drafting personnel in the preparation, revision, and completion of engineering drawings. This manual sets forth the minimum requirements acceptable at GSFC for the preparation of engineering drawings for flight hardware and ground support systems.